Generally front wheel seals are those used in front hubs. They prevent leaks of grease oil in the bearing and also penetration of water and foreign substances from the outside.
Vehicles using disc break generate dust of disc break. Front Wheel sealｓ also prevent penetration of dust of disc break.
In general, most double tires equipped in truck vehicles have a hub seal (inner) and a shaft seal (outer).
The hub seal prevents grease from leaking into the hub bearing and also prevents water and foreign substances from penetrating from the outside. They require press-fit when installing it.
The shaft seal prevents leaks of hub bearing grease and also prevents differential oil from penetrating into the hub bearing. It does not necessarily require press-fit. It is strongly recommended that the hub seal (inner) and shaft seal (outer) be replaced at the same time.
A gasket is installed between the main body of wheel hub and hub cover (cap) to prevent leaks of bearing grease and also prevents water and foreign substances from penetrating from the outside.
We offer a wide range of materials, from commonly used paper and non-asbestos materials to the latest materials with excellent serviceability, depending on the type of vehicle.
O-rings for car air conditioner gas R12 and R134a are packaged in a special case which is easy to handle and are available for a wide range of car models.
We also sell them individually for corporate use.
This gasket packing is used mainly for throttle vehicles equipped with ISCV, which may cause problems of ISCV valves and sensors.
ISCV requires disassembly and cleaning, but the gasket packing cannot be reused.
So it must be replaced. Heat-resistant material is used for the gasket packing.
There are five types of kits: front wheel kit, rear wheel kit, front and rear wheel kit, rear dead axle kit, and trailer seal kit.
The oil seal kit contains front and rear wheel seals for trucks with a payload of 2 tons or more, along with gasket packings, lock washers, lock bolts, split pins, and other parts to be simultaneously replaced, all parts are packed in one set.
Set-buying prevents forgetting to order or losing the replacement parts.
This is an overhaul seal kit for power steering.
A complete package of consumable parts required for overhaul.
Gear Housing Kit and Pump Kit are available.
Drive pinion oil seals are used at the connection of differential gear and propeller shaft and prevent leak of differential oil and also foreign substances from the outside.
As the oil seals are often installed facing the vehicle travelling direction, there is concern about penetration of foreign substances. So oil seal with a special shape (UES-9 type) is used.
Further, since they are used in the location of extremely high temperature. resistant material is applied
Differential side oil seals which are installed on both sides of the differential and are mainly used at the connection with the drive shaft.
Those oil seals prevent the transmission oil from leaking in the transmission case of front-wheel drive vehicles and differential oil from leaking in the differential of rear-wheel drive vehicles. ( The reverse is true of rear-engine vehicles.)
Heat-resistant material is used.
Transmission rear oil seals are used at the connection between the rear end of the transmission and the propeller shaft in longitudinally mounted engine vehicles and prevent leaks of transmission oil and penetration of foreign substances from the outside.
Heat-resistant materials are used for this oil seal.